Description
The B&G Fastnet bus terminator: a 100 ohm resistor that closes one end of an H3000 or H5000 Fastnet network. A Fastnet backbone needs a terminator at each end, which gives a measured resistance of roughly 50 ohms across the green and white signal pair with the processor switched off. A missing or failed terminator typically shows up as intermittent data or displays dropping off the bus altogether.
PRODUCT DETAILS
- Genuine B&G Fastnet bus terminator
- 100 ohm resistor fitted across the green and white signal wires
- One terminator required at each end of the Fastnet backbone
- For H3000 and H5000 Fastnet networks
- Correct termination gives about 50 ohms across the signal pair
No exploded diagram available for this product.
No compatible transducers listed for this product.
No spares or accessories listed for this product.
Electrical
| Termination resistance | 100 ohms |
| Fitted across | Green and white signal wires |
| Expected bus resistance | Approx. 50 ohms across signal pair with two terminators fitted |
Compatibility
| Network | B&G Fastnet (H3000, H5000) |
| Quantity required | 2 per network (one at each end) |
No videos available for this product.
No downloads available for this product.
No frequently asked questions for this product.
