Kicker Marine Audio

Kicker Audio KM Marine 10 Inch Subwoofer 4 Ohm

£251.94
Tax included. Shipping calculated at checkout.
KA45KMF104
A 10-inch free-air marine subwoofer that delivers deep, loud bass with no enclosure required. Corrosion-resistant polymer basket, Santoprene surround and stainless hardware stand up to sun and spray. 4 ohm single voice coil.

Collection or delivery in 1-2 weeks

Pickup available at Mercury Yacht Harbour

Usually ready in 2-4 days

Description

The Kicker KMF10 is a 10-inch free-air marine subwoofer that delivers serious low end without the need for a sealed or ported enclosure, so you can add real bass to a boat where space for a box is scarce. An injection-moulded polypropylene cone, co-moulded Santoprene surround and UniPlate back plate and pole piece give it the excursion and control to fill an open deck, and it is happiest with around 175 watts of clean power.

Every part of the KMF10 is built to live on the water. The polymer basket resists corrosion, the motor uses thick tinsel leads and a large ceramic magnet, and a protective terminal cap keeps the connections dry. The subwoofer meets or exceeds ASTM standards for UV and salt/fog exposure and ships with stainless steel mounting hardware and a rear gasket for a clean, sealed install. This is the 4 ohm single voice coil version.

PRODUCT DETAILS

  • Free-air 10-inch marine subwoofer, no enclosure required
  • 350 watts peak power with 175 watts recommended RMS
  • 4 ohm single voice coil for flexible amplifier wiring
  • Injection-moulded polypropylene cone with Santoprene surround
  • Corrosion-resistant polymer basket and protective terminal cap
  • Meets or exceeds ASTM UV and salt/fog exposure standards
  • Stainless steel mounting hardware and rear gasket included
  • 1 x 10-inch free-air subwoofer
  • 1 x rear gasket
  • 8 x mounting screws
  • 8 x mounting screw clips
  • 1 x manual

No exploded diagram available for this product.

No compatible transducers listed for this product.

No compatible products found.

Audio

Peak Power350 W
Recommended RMS Power175 W
Rated Impedance4 ohm
Frequency Response30 Hz - 500 Hz
Voice CoilSingle (4 ohm)
Free-AirYes

Mounting

Cutout Diameter9-3/16 in (23.2 cm)
Mounting Depth5 in (12.7 cm)

General

IP RatingWeather-resistant, ASTM B117 salt fog and ASTM G154 UV tested
LED LightingNo
Sold AsEach
Warranty3 years

No videos available for this product.

No downloads available for this product.

Does the KMF10 need an enclosure?
No. The KMF10 is a free-air subwoofer designed to mount in a baffle or the boat's structure without a sealed or ported box, which makes it ideal where there is no room for an enclosure. A rear gasket is included so the mounting surface seals cleanly.
How much power should I give the KMF10?
Kicker recommends around 175 watts RMS of clean power, and the subwoofer handles up to 350 watts peak. Matching an amplifier to that figure gives you strong, controlled bass without over-driving the driver.
Should I choose the 2 ohm or 4 ohm version?
This is the 4 ohm single voice coil model, a common impedance that pairs easily with many marine amplifiers. Choose the version that matches your amplifier's rated output and wiring plan; a 2 ohm version (KMF102) is also available.